196
See also: intface, maxusers, myremote, numnodes, pbbs, restore
RESTORE DEFAULT
immediate
When RESTORE D is given, the KPC-3 Plus will revert to its factory default settings,
perform its AUTOBAUD routine, and erase PBBS memory (deleting all messages and
non-default PBBS parameter settings).
See also: reset
RETRY n (n = 0 - 15)
default 10
This command specifies the number of packet retries. Packets are re-transmitted n
times before an operation is aborted. The time between retries (when no
acknowledgment is received) is specified by the command FRACK.
See also: ax25l2v2, frack, relink, tries
RING {ON | OFF}
default ON
When ON, three bell characters ($07) are sent to the terminal with each ―***
CONNECTED TO‖ message (when another station initiates the connect).
RNRTIME n (n = 0 - 255)
default 0
RNRTIME is set in 10-second increments. If a connection stays in a remote device busy
state (continues to receive RNR frames) for RNRTIME, the TNC will disconnect. If a KA-
Node connection stays in a remote device busy state for RNRTIME the KA-Node will
disconnect the input and output sides of the KA-Node circuit. Setting RNRTIME to 0
disables this function.
See also: mresp
RPRINT text (text up to about 250 characters)
immediate
This is an immediate command which sends the ―text‖ string to the device attached to
the RS232 port (e.g. a GPS unit). It is intended to allow a remote SYSOP (connected to
To Next Page
Loading...
