Kantronics KPC-3 Plus - Connect to Your Mailbox

60
Step 3. The KPC-3 Plus will send a short ―HELP‖ message about the command, for
display on your monitor.
View Current Values of Parameters
To see the current value of parameter(s) for any variable (other than the ―immediate‖
commands, like CONVERS, that are simple actions, not settings):
Step 1. Go to COMMAND mode, as described above (if you are not already there).
Step 2. Type the name of the command for which you want to see current parameter
value(s).
Step 3. The KPC-3 Plus will send a message consisting of the name of the command
and the value(s) of its parameters for display on your monitor. For example, if
you type INTFACE, you will see INTFACE NEWUSER if you are currently in
the NEWUSER mode.
As explained in the ―Command Reference‖ chapter, the DISPLAY command can be
used to see current values of selected sub-sets of commands.
Change the Value of a Parameter
To change the current value of parameter(s) for any variable (other than the
―immediate‖ commands, like CONVERS, that are simple actions, not settings):
Step 1. Go to COMMAND mode, as described above (if you are not already there).
Step 2. Type the name of the command for which you want to change the current
parameter value(s), type one or more spaces, and enter the new value(s) you
want for the parameter(s) for the command.
Step 3. The KPC-3 Plus will immediately change the value(s) to the values(s) you
have just entered.
If you enter a value that is not possible (e.g., INTFACE MOON), you will get an error
message (―EH?‖).
To confirm that the current value(s) is what you want, enter the name of the command
and press ENTER. The KPC-3 Plus will send a message consisting of the name of the
command and the current value(s) of its parameter(s) for display on your monitor.
Connect to Your Mailbox
You are now ready to try your first connect.
A good first connect (which also shows you an important part of your KPC-3 Plus), is to
simply connect to your own personal mailbox, built in to the KPC-3 Plus:
This is an internal connect, so your radio does not need to be connected.