Kantronics KPC-3 Plus - Using NEWUSER Commands

59
MONITOR - When ON allows the KPC-3 Plus to display monitored packets on the
screen. When OFF, no packets will be displayed unless someone actually connects to
you.
MHEARD - Displays a short list of stations that have recently been heard by your
KPC-3 Plus.
MYCALL - Used to set the callsign of your KPC-3 Plus.
MYPBBS - Sets the callsign used for your personal mailbox in the KPC-3 Plus.
PBBS - Used to set the size (kbytes) of the Personal BBS in your KPC-3 Plus.
RESET - Causes the KPC-3 Plus to perform a soft reset.
STATUS - Displays the status of the current stream and all connected streams.
TXDELAY - Sets the time delay between Push-to-Talk and the beginning of data.
UNPROTO - Sets the destination field and digipeaters used for any unconnected data
packets transmitted.
VERSION - Displays the current version number of the EPROM (firmware) in your
KPC-3 Plus.
Using NEWUSER Commands
A brief look at the use of selected NEWUSER commands will give you the familiarity
you need to continue on your own using KPC-3 Plus commands.
Check Your KPC-3 Plus’ Version Number and ID
To check your KPC-3 Plus‘ version number and ID all you need to do is ask to see the
current setting of the command called VERSION:
Step 1. Go to COMMAND mode (if you are not already there).
Step 2. Type ―VERSION‖ (or the short form, ―V‖) and press the ENTER key to enter
the command.
Step 3. The KPC-3 Plus will send its version number and other ID information for
display on your monitor.
Get Help
To see a one-line explanation of any command that is currently available:
Step 1. Go to COMMAND mode (if you are not already there).
Step 2. Type ―HELP,‖ (or ―?‖) followed by one or more spaces and the name of the
command for which you want help.