16
FCC Declaration of Conformity:
NOTE: This equipment, Kantronics‘ KPC–3 Plus, has been tested and found to comply
with the essential emission and immunity requirements of the EMC Directive FCC Title
47, Part 15, Subpart B. The test results are on file at the corporate offices of Kantronics.
Type of Equipment: Information Technology Equipment
Class of Equipment: Class B
CE Marking Considerations
The following cautions pertain to CE Marking of this product:
All cables connecting to DC IN, PORT 1 (VHF), and COMPUTER must be 3 m
in length
A cable for GPS or telemetry (control output or A/D input) connected to the
COMPUTER port may be 3 m in length.
All cables, except for the DC IN port, must be shielded with the shield properly
terminated 360 to the connector. See note 2 in the RF Interference section
The nominal 12 V dc power must be supplied from a CE marked or third party
approved power brick (wall wart) or ac to dc power supply. If a homemade power
supply is used the components making up the supply must meet IEC/EN
standards for such components.
To Next Page
Loading...
