Kantronics KPC-3 Plus - KPC-3 Plus Parts Layout

236 pages

Save Page as PDF

To Next Page

To Next Page

To Previous Page

To Previous Page

Loading...

235

KPC-3 Plus Parts Layout

A

B

C

D

1

2

3

4

Table of Contents

Contact Us2
Revisions3
Warranty Registration4
License Agreement5
- Table of Contents7
Limited Warranty9
- Return/Repair Procedures12
- Radio Frequency Interference Statement14
- RFI Suppression15
- FCC Declaration of Conformity16
Introduction17
- Welcome17
- Overview of this "User's Guide" Manual17
- Major Uses of Your KPC-3 Plus17
- Package Contents18
- Additional Parts for Your Packet Radio Station18
- Our Assumptions about You19
- Documentation Conventions19
- Overview of Packet Radio19
- Inside a TNC - the KPC-3 Plus27
Installing Your KPC-3 Plus29
- The Major Components of Your Station30
- Back Panel30
- How the Parts of Your Station Are Connected33
- Connect Your KPC-3 Plus to a Power Source34
- Connect Your KPC-3 Plus to Your Computer36
- Configure Your KPC-3 Plus39
- Connect the KPC-3 Plus to a Transceiver43
- Connecting to a GPS Device (Optional)53
Getting Started54
- The Front Panel of the KPC-3 Plus55
- Beginning a Packet Session55
- Giving Commands and Transmitting Data56
- NEWUSER Commands57
- Using NEWUSER Commands59
- Connect to Your Mailbox60
- Monitor Communications from Nearby Stations61
- Communicate Directly with a Nearby Station62
Modes of Operation64
- Packet Mode of Operation64
- Remote Access to Your TNC74
PBBS (Personal Mailbox)76
GPS NMEA Interfacing91
- GPS Operations95
KA-Node104
Introduction to Basic Packet Networking112
K-Net Network Node114
- K-Net Node Commands115
- WEFAX Mode137
- Other Modes of Operation139
- Modem Mode140
- Kantronics Host Mode Operation141
- KISS Mode142
Command Reference146
- Introduction146
Commands151
Appendix A: Advanced Installation209
- Precautions209
- Cable Wiring209
- Connecting to the Computer (DSUB-25)209
- Connecting to Your Radios212
Appendix B: Advanced Information215
- Assembly and Disassembly215
- Hard Reset215
- Calibration/Equalization216
- PTT (Push-To-Talk) Watchdog Timer217
- Microprocessor Watchdog Timer217
- A/D Converter217
- KPC-3 Plus Jumpers218
Appendix C: Options for the KPC-3 Plus221
- Low Power Operation221
- Expanding the RAM in the KPC-3 Plus221
- Installing the Optional Real-Time Clock Module221
- Replacing the Lithium Battery222
Appendix D: in Case of Difficulty223
- KPC-3 Plus Does Not "Sign-On" to Computer223
- You Are Unable to Make a "Connect223
  - Cannot Transmit223
  - Cannot Return to Command Mode224
Appendix E: Additional Information225
- Specifications225
- Messages from the KPC-3 Plus226
- ASCII Chart232
- KPC-3 Plus Parts List233
- KPC-3 Plus MX Parts List234
- KPC-3 Plus Parts Layout235
- KPC-3 Plus MX Parts Layout236

Related product manuals

Kantronics KAM 98

Preview: Kantronics KPC-3

Kantronics KPC-3