58
ECHO - When ON characters you type on the keyboard will be echoed back to your
terminal. When OFF characters you type will not be echoed.
HELP - Displays a complete list of all available commands on your screen.
INTFACE - Selects the NEWUSER command set or the complete (TERMINAL)
command set. Also used to place the KPC-3 Plus in HOST, BBS, KISS, XKISS,
MODEM or GPS mode.
K - Switches the KPC-3 Plus into the CONVERS mode (same as CONVERS).
Select the current interface mode
INTFACE: Set the current interface mode to NEWUSER, TERMINAL, BBS, HOST, KISS, XKISS, GPS or
MODEM. Default is NEWUSER, which makes available just the basic commands listed here.
Get help and other information about your KPC-3 Plus
HELP: List all available commands or a brief description of a specified command.
DISPLAY: Show current values for all parameters or for a specified group of parameters.
VERSION: Show the version number of the EPROM (firmware) installed in your KPC-3 Plus.
Configure your KPC-3 Plus
RESET: Restart the modem -- equivalent
to turning your KPC-3 Plus
OFF, then ON again ("soft reset").
MYCALL: Change your KPC-3 Plus‘ callsign.
DAYTIME: Set your KPC-3 Plus‘ software (and optional hardware) clock.
TXDELAY: Set the transmitter key-up delay (default is 300 ms).
DWAIT: Time delay imposed to insure that digipeaters have priority access to the radio frequency.
Display communication activity
MONITOR: Display packets from other stations (default is ON).
STATUS: Display current I/O stream and link status of other connected streams.
MHEARD: Display a list of stations recently heard by your KPC-3 Plus.
Define your KPC-3 Plus’ use of characters sent to it from your computer
ECHO: Display characters you type (default is ON, for use with full duplex communication programs).
BKONDEL: Select the effect of entering a "delete" (i.e., erase the previous character or display a "\").
DELETE: Change which key your KPC-3 Plus will interpret as "delete" (default is backspace key).
Configure your personal mailbox (PBBS)
MYPBBS: Change the callsign of your PBBS.
PBBS: Change the size of your PBBS (i.e., RAM used).
Session control
CONNECT: Start a session (i.e., connect to a station) and automatically switch to CONVERS Mode.
DISCONNE: End a session (i.e., disconnect from a station).
UNPROTO: Set a destination and digipeater path for unproto packet transmissions.
Switch from giving your KPC-3 Plus commands to using it to send data
CONVERS: Switch from COMMAND communication mode to CONVERS (i.e., conversation)
Mode. The default way to go back to COMMAND Mode is to enter <Ctrl+C>.
K: Same as CONVERS.
NEWUSER Commands
NEWUSER commands are a subset of the full TERMINAL command set. NEWUSER commands are all
you need for basic, beginner operations of your packet radio station. These commands
are explained in the Command Reference section of the manual.
To Next Page
Loading...
