CAN RANGER OPERATION
16
or the actuator is not
functioning correctly. Try the
other handles to see if the
one of the other handles
control the displayed position.
If so, swap the actuator
locations or re-ID the
actuators. If no handle
controls the position, make
sure the actuators are linked
to the valves.
If the SWING handle can
change the position on the
display, center the handle. It
should be about 1.5 inch.
Note that the actuator total
travel is 3 inch; therefore 1.5
is the center position. If it is
not close, adjust the linkage
to the valve handles and push
<SET>.
The next screen will be to set
the Fast Counter Clockwise
Swing. Push the SWING
Handle all the way in the
direction for Counter
Clockwise Swing. Hold it there
and push <SET>.
Next the Slow Counter
Clockwise Swing needs to be
set. Hold the SWING Handle
in the position for slow
Counter Clockwise Swing, and
press <SET>.
The next screen will be to set
the Engine Stop Position for
Counter Clockwise Swing.
Hold the SWING Handle in the
position that you want the
Engine to be stopped and
push <SET>.
The next screen will be to set
the Fast Clockwise Swing.
Push the SWING Handle all
the way in the direction for
Clockwise Swing. Hold it there
and push <SET>.
To Next Page
Loading...
