CAN RANGER OPERATION
17
Next the Slow Clockwise
Swing needs to be set. Hold
the SWING Handle in the
position for slow Clockwise
Swing, and push <SET>.
The next screen will be to set
the Engine Stop Position as
described above for Clockwise
Swing. Hold the SWING
Handle in this position, and
push <SET>.
The next screen lets you
Enable or Disable the Auto
Center feature for the Swing
Actuator. Push <SET> to
toggle between ENABLE and
DISABLE. Push → Next menu.
The final step in calibrating
the SWING function is to save
the settings or if you don’t
want to save them, just
escape.
PUSH SET TO SAVE
USE ↑ TO QUIT
Pushing <SET> will save the
settings. Pushing ↑ will exit
the Swing Calibration and will
revert to the previous
settings.
If you push <SET> the
controller will automatic move
to Telescope setup. If you
want to calibrate the
Telescope function next, push
<SET>.
Repeat this procedure for the
Telescope, Winch and Boom
actuators. If enabled, also
repeat this for Boom 2 and
Telescope 2. If this is the
only actuator that requires
calibration or to exit
calibration keep pressing the
right button (FWD arrow).
The Actuator calibration is
now complete. Make sure
To Next Page
Loading...
