English 5.906-591.0 Rev. 00 (01/14) 21
AEZK Uninstall / install cylinder head
1 Seals control piston
2O rings
3 Guide sleeve
4 Control valve
5 Valve gear casing
6 Cylinder head
Disconnect the cylinder head from the valve gear cas-
ing.
Pull of the seal of the control piston.
Pull out the control valve.
Pull out the guide bush.
Note
Check O-rings for damage.
Check and ensure that it moves freely.
Check components for wear / damage.
AEZK Uninstall / install cylinder head
1 Pressure disc
2 Ball bearing
3Screw
4 Swash plate
Drain and collect the oil.
Remove pressure disc.
Remove ball bearing.
Loosen the screw.
Remove swash plate.
Note
Check components for wear / damage.
Pay attention to the correct fitting position during reinstal-
lation.
AESV Uninstall / install control valve
AETS Uninstall / install swash plate
Torques Nm
Screw 10...13
Amount of oil ml
15W40 120
To Next Page
Loading...
