English 5.906-591.0 Rev. 00 (01/14) 27
ABGH Uninstall / install appliance hood
Unclip casing cover.
Unhook lever of appliance switch.
Remove appliance switch.
Disconnect the connectors.
Note
Observe the plug arrangement during installation.
Pay attention to the correct fitting position during reinstal-
lation.
Service group does not contain any maintenance and in-
spection points.
The service group does not contain any peculiarities.
AHSE Uninstall / install appliance switch
1 Guidance
2 Lever appliance switch
3 Plug connections
4 Power switch S1
5 Covering lid
050 Maintenance and inspection
060 Error diagnosis
Findings Possible cause Correction
Pump does not run or suddenly comes
to a standstill during operations
Power supply interrupted Check fuses and electrical connections
Power switch Check appliance switch.
Power switch Check the electrical connections.
070 Peculiarities/ others
110 Replacement times
Basic work Description Work value
AHNK Uninstalling / installing mains cable
AHKS Uninstalling / installing capacitor
AHSE Uninstall / install appliance switch
To Next Page
Loading...
