17
M5101-EN Rev. B |
4.4 6 Switching Modes (Remote Control / Standalone)
To switch to Remote Control mode from the Standalone Main mode simply tap the
Validator icon.
To switch to Standalone mode from Remote Control mode, click on the cancel X icon in
the upper right-hand corner. A new window will display with the following three options: End
Remote Control, Switch Off, and Cancel. Tap on End Remote Control, which will take
you to the Standalone home screen.
4.4.7 Powering Off
To power off the unit from Remote Control screen, tap on the cancel X icon in the upper
right-hand corner then Switch Off. A Switch Off Calibrator screen will appear with a
temporary message stating, “system data are saved – please wait” eventually followed by
another message “you can now turn off the calibrator” at which point you can flip the switch
in the front of the unit.
To power off from Standalone screen, tap on the power icon in the upper right-hand corner
and follow prompts as listed above.
Note: If the temperature value is greater than 40°C then a message will appear stating,
“calibrator is reaching safe temperature – please wait.” Once the value drops below
40°C then a new message will appear informing that “you can now turn off the
calibrator.”
Chapter 4. Getting Started
To Next Page
Loading...