Kaye LTR-150 - Standalone Main Screen Icons; Calibrator Set Up Icon; Measurement Reports Icon; Remote Control Icon

30
| Kaye LTR-150 - Dry Block & Liquid Bath All-in-One Temperature Calibrator
 Calibrator Set Up: By using the tools icon, you can reach the “Calibrator Set Up” screen. There,
you can change the settings of the calibrator.
 Measurement Reports: By using the reports icon, you can reach the “Select measurement report”
screen. There, you can select saved measurement logs and view them.
 Remote Control: By using the validator icon, you can switch back to remote control screen for
automatic calibration with Kaye products.
 Test Task Selection: Usingthisparametereld,youcanreachthe“SelectTestTask”screen.There,
youcanselectthesavedtesttasksandcreateorcongureyourowntesttasks.
 Power Off: By using the power icon, you can switch the calibrator off.
 Selected Test Task Details: The reference temperature, the set temperature as well as additional
information related to the selected test task.
 Alarm Signal: By tapping the alarm annunciator icon, you can switch the alarm signal on or off.
Note: Todenewhenalarmsignalistobeactivated,taponthealarmsettingicon.
 Start / Stop Slider: The start / stop slider is used to start or end the testing process.
 Configuration Range: Youcanusetheparametereldsofthecongurationrangetogettothe
parameter screens of the calibrator.
Chapter 7. Standalone Manual Mode