45
1. Use needle-nose pliers to carefully remove the chain locking clamp, disassemble the chain link, and remove the chain;
2. Remove the large and small sprocket with tools;
3. Install the large sprocket, small sprocket and chain in the reverse order of disassembly and adjust the swing of the chain;
4. When installing the chain, the locking clip must be on the outside of the vehicle, and the open end is opposite to the running direction of the
chain to prevent the locking clip from being thrown out by the centrifugal force generated by the high-speed running lock of the chain.
5. Clean the chain and gear plate regularly, and add grease in time. If there are rain, snow and muddy roads, the maintenance of the chain and gear
plate should be strengthened.
Note:
Before each ride, check whether the transmission system is working properly. If you notice any defect or damage, you must check and
repair it immediately, and replace the parts of the transmission system if necessary, and the parts can only be obtained from a qualified
dealer. Your dealer can recognize any signs of wear and can replace parts that are needed if necessary. Therefore, if necessary, bring the
vehicle to the dealer for testing.
To Next Page
Loading...
Need help?
General
