19
4.5. Left switch combination
① Overtaking light switch
②Headlamp dimmer switch
③Hazard warning flashing light
④Turn signal switch
⑤Horn button
1. Overtaking light switch
When the "passing light button" is pressed, the overtaking light is on;
When the "passing light button" is released, the overtaking light does not light up.
2. Headlight dimmer switch
The headlight switch has two operating states: turn on the ignition switch lock, and turn the "headlight, position light switch" to this sign“ ”
“Headlamp dimmer switch” turn to this sign“ ”is low-beam.
“Headlamp dimmer switch” turn to this sign“ ”is high-beam.
Fig.7 Left switch combination
Warning:
Please change the state of the far and low beams appropriately according to the road conditions. If there is an oncoming car, please
adjust the light to the low beam state to avoid glare of the lights affecting the driving state of the drivers of the oncoming car and
cause traffic accidents.
Note：
Overtaking light is not on when current lamp light is in the high beam state“ ”
To Next Page
Loading...
Need help?
General
