53
Figure 30 Inspection of rear brake friction lining
9.2 Check the brake pads of the rear brake
Check the minimum thickness of the brake pads (A). The minimum thickness of the brake
friction pad: A=1.5mm. If the thickness is lower than the minimum thickness: please replace the
friction plate in time. If the friction plate is found to be damaged or cracked: please replace the
friction plate in time
Note:
The friction lining will gradually wear out during the braking process of the vehicle. The braking effect will gradually decrease. To
ensure the safety of you and the vehicle, please check it frequently and replace it in time. If you do not understand the specifications
of the friction plate or cannot replace it by yourself, please go to the designated after-sales point for repair.
To Next Page
Loading...
Need help?
General
