appeNdiCes
40
QuNeo
Preset 16 (BeatMaker - iPad):
Below is an image showing how the QuNeo is mapped to BeatMaker’s controls in factory preset #16. Each pad is
in Drum Mode and outputs a MIDI note to trigger one of BeatMaker’s drum pads. The vertical sliders each output
a location CC to control the volume for tracks 1-4 in BeatMaker. The horizontal sliders are set up to control the rst
four sliders on the currently selected track’s effects. Using the bank buttons next to the horizontal sliders you can
access control for all three of a track’s effects (bank four has nothing set as there are a maximum of three effects per
track). The left rotary is mapped to lter cutoff frequency and the right rotary is mapped to lter resonance. The
long slider controls a track’s lter key.
This image shows what MIDI data will output for each sensor in the “BeatMaker iPad” preset. In this preset the Pads
use Drum Mode. Banks are enabled only for the Horizontal Sliders. Rotaries are set to use Location instead of
Direction. Pass Thru Widths for the rotaries are set to 127. Velocity response is variable for all notes. All Pressure
sources send out continuous CC values.
For more information about using the BeatMaker Template read the BeatMaker Template Quickstart document in the
QuNeo directory: “Documentation/Template Quickstarts”.
To Next Page
Loading...
Need help?
General