appeNdiCes
39
QuNeo
Presets 15 (Korg iMS-20 - iPad):
This preset is for use with Korg’s iMS-20 synthesizer for iPad. This allows the QuNeo to play minor pentatonic notes
from the iMS-20 and adjust voltage controlled oscillators and effects. Each pad will send out the same pressure CC#
to control a low pass lter cutoff frequency. The X axis of each pad will control Pitch Bend. The Y axis of each pad
will control the second voltage control oscillator. The Horizontal Sliders and the Long Slider control effects. Use the
Rotaries to control the mod wheel and the tuning. The Vertical Sliders control the VCO waveforms and pulse width.
The image below shows what each sensor controls in the Korg iMS-20 synthesizer:
This image shows what MIDI data will output for each sensor in the “Korg iMS-20 - iPad” preset. In this preset the
Pads use Drum Mode. Banks are not enabled. Rotaries are set to use Direction instead of Location. X/Y sources
on the Pads are set to return to 63. Velocity response is variable for notes on Pads. All Pressure sources send out
continuous CC values.
For more information about using the iMS-20 Template read the iMS-20 Template Quickstart document in the
QuNeo directory: “Documentation/Template Quickstarts”.
To Next Page
Loading...
Need help?
General