To Next Page

To Previous Page

2000-903-01 Rev. C / October 2007 Return to Section Topics 1-17

Model 2000 Digital Multimeter Quick Start Guide Section 1: Introduction

SCPI command subsystems

NOTE 1. Brackets ([]) are used to denote optional character sets. These

optional characters do not have to be included in the program

message. Do not use brackets in the program message.

2. Angle brackets (<>) are used to indicate parameter type. Do not

use angle brackets in the program message.

3. Upper case characters indicate the short-from version for each

command word.

Table 1-5

Signal oriented measurement commands

Command Description

:CONFigure:<funct

ion>

:FETCh?

:READ?

MEASure[:<functio

n>]?

Places the Model 2000 in a

“one-shot” measurement

mode for the specified

function.

Requests the latest reading.

Performs an :ABORt,

:INITiate, and a :FETCh?.

Performs an :ABORt,

:CONFigure:<function>, and

a :READ?.

Keithley 2000 Quick Start Guide

Other manuals for Keithley 2000