Keithley 2231A-30-3 - CALIBRATION Subsystem Commands

Model 2231A Triple-channel DC Power Supply Reference Manual Section 5: SCPI command reference
077100401/September 2014 5-7
Unit V
Returns None
Examples APP:VOLT 3,3,1
[SOURce:]APPly:CURRent[:LEVel][:IMMediate][:AMPLitude]
This command is to set current to all channels at the same time.
Item Description
Group Source
Syntax [SOURce:]APPly:CURRent[:LEVel][:IMMediate][:AMPLitude]
[SOURce:]APPly:CURRent[:LEVel][:IMMediate][:AMPLitude]?
Arguments Arg1: current setting for CH1
Optional Arg2: current setting for CH2
Optional Arg3: current setting for CH3
Unit A
Returns None
Examples APP:CURR 1,1,0.6
CALibration subsystem
The commands in this subsystem configure and control the calibration operations.
CALibration:SECure:[STATe]
This command clears all the specified strings and returns the display back to voltage and current readingS.
Item Description
Group Calibration
Syntax CALibration:SECure:[STATe] {<ON|OFF>,[<password>]}
CALibration:SECure:STATe?
Arguments 0|1|ON|OFF, ‘2231’
Returns 0|1
Examples CAL:SEC 0, ‘2231’; CAL:SEC OFF
CALibrate:VOLTage:LEVel