EasyManuals Logo
Home>Keithley>Measuring Instruments>2614B

Keithley 2614B Reference Manual

Keithley 2614B
864 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #440 background imageLoading...
Page #440 background image
Section
7: TSP command reference Series 2600B System SourceMeter® Instrument
Reference Manual
7-100 2600BS-901-01 Rev. B / May 2013
Example
gm_array = gm_vsweep(smua, 0, 5, 20)
gm_array, ibuf = gm_vsweep(smua, 0, 5, 20)
gm_array, ibuf, vbuf = gm_vsweep(smua, 0, 5, 20)
SMU A returns Gm values only.
SMU A returns Gm and reading buffer
with measured currents.
SMU A returns Gm and reading buffers
with measured currents and voltages.
Also see
gm_isweep() (on page 7-98)
KIParlib factory script (on page 5-22)
gpib.address
This attribute contains the GPIB address.
Type TSP-Link accessible Affected by Where saved Default value
Attribute (RW)
No
Not applicable
Nonvolatile memory
26
Usage
address = gpib.address
gpib.address = address
address
The GPIB address of the instrument (0 to 30)
Details
The GPIB address value is set to 26 at the factory. The address can be set to any address value between 0 and
30. However, the address must be unique in the system. It cannot conflict with an address that is assigned to
another instrument or to the GPIB controller.
A new GPIB address takes effect when the command to change it is processed. If there are response messages
in the output queue when this command is processed, they must be read at the new address.
If command messages are being queued (sent before this command has executed), the new settings may take
effect in the middle of a subsequent command message, so care should be exercised when setting this attribute
from the GPIB interface.
You should allow ample time for the command to be processed before attempting to communicate with the
instrument again. After sending this command, make sure to use the new address to communicate with the
instrument.
The reset() function does not affect the GPIB address.
Example
gpib.address = 26
address = gpib.address
print(address)
Sets the GPIB address and reads the address.
Output:
2.600000e+01
Also see
GPIB setup (on page 2-104)

Table of Contents

Other manuals for Keithley 2614B

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Keithley 2614B and is the answer not in the manual?

Keithley 2614B Specifications

General IconGeneral
BrandKeithley
Model2614B
CategoryMeasuring Instruments
LanguageEnglish

Related product manuals