To Next Page

To Previous Page

Series 2600B

System SourceMeter® Instrument Reference Manual Section 2:

General operation

2600BS-901-01 Rev. B / May 2013 2-49

Hazardous voltages may be present on the output and guard terminals. To prevent

electrical shock that could cause injury or death, never make or break connections to the

Series 2600B while the output is on. Power off the equipment from the front panel or

disconnect the main power cord from the rear of a System SourceMeter

instrument before

handling cables connected to the outputs. Putting the equipment into standby does not

guarantee the outputs are not powered if a hardware or software fault occurs.

Maximum floating (common mode) voltage for a SMU is 250 V. Exceeding this level could

damage the instrument and create a shock hazard. See Floating a SMU later in this section

for details on floating the SMUs.

The input/output connectors of the System SourceMeter

instrument are rated for

connection to circuits rated Measurement Category I only, with transients rated less than

1500 V peak. Do not connect the Series 2600B terminals to CAT II, CAT III, or CAT IV

circuits. Connections of the input/output connectors to circuits higher than CAT I can cause

damage to the equipment or expose the operator to hazardous voltages.

To prevent electric shock and/or damage to the System SourceMeter

instrument, when

connecting to a source with a greater current capability than the Series 2600B, a user-

supplied fuse, rated at no more than 20 A SLO-BLO, should be installed in-line with the

Series 2600B input/output connectors.

Keithley 2614B Reference Manual

Other manuals for Keithley 2614B