Keithley DMM7510 Calibration Manual

In this section:
TSP commands ........................................................................ 4-1
TSP commands
Introduction
This section contains detailed information on the Model DMM7510 remote calibration commands.
acal.count
This attribute returns the number of times automatic calibration has been run.
Type TSP-Link accessible Affected by Where saved Default value
Attribute (R)
Yes
Not applicable
Not applicable
Not applicable
Usage
value = acal.count
value
The number of times auto calibration has been run
Details
The number of times that auto calibration has been run since the last factory calibration. The count
restarts at 1 after a factory calibration.
Example
print(acal.count)
Returns the number of times auto calibration has been
run.
Example output:
15
Also see
Auto calibration (on page 2-4)
acal.run() (on page 4-6)
Section 4
TSP command reference

Keithley DMM7510 Specifications

General

Brand	Keithley
Model	DMM7510
Category	Multimeter
Language	English