2400 Series SourceMeter
®
User’s Manual Common Commands 16-7
*WAI — wait-to-continue
Effectively, the *WAI command is a No-Op (no operation) for the SourceMeter and thus,
does not need to be used.
Two types of device commands exist:
• Sequential commands — A command whose operations are allowed to finish
before the next command is executed.
•Overlapped commands — A command that allows the execution of subsequent
commands while device operations of the Overlapped command are still in
progress.
The *WAI command is used to suspend the execution of subsequent commands until the
device operations of all previous Overlapped commands are finished. The *WAI command
is not needed for Sequential commands.
Wait until previous commands are completed
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
