2400 Series SourceMeter
®
User’s Manual SCPI Command Reference 18-73
AUTO
:SOURce[1]:CLEar:AUTO <b>
Parameters <b> = 1 or ON Enable auto output-off
= 0 or OFF Disable auto output-off
Query :AUTO? Query state of auto output-off
Description This command is used to control auto output-off for the source. With
auto output-off enabled, an :INITiate (or :READ? or MEASure?) will
start source-measure operation. The output will turn on at the beginning
of each SDM (source-delay-measure) cycle and turn off after each mea-
surement is completed.
With auto output-off disabled, the source output must be on before an
:INITiate or :READ? can be used to start source-measure operation. The
:MEASure? command will automatically turn on the source output.
Once operation is started, the source output will stay on even after the
instrument returns to the idle state. Auto output-off disabled is the *RST
and :SYSTem:PRESet default.
WARNING With auto output-off disabled, the source output will remain on after
all programmed source-measure operations are completed. Beware of
hazardous voltage that may be present on the output terminals.
NOTE For the Model 2430 Pulse Mode, auto output-off is always enabled. This com-
mand is ignored.
Select function modes
SHAPe <name> (Model 2430 only)
:SOURce[1]:FUNCtion:SHAPe <name> Select output mode
Parameters <name> = DC Select DC Mode
PULSe Select Pulse Mode
Query :SHAPe? Query selected output mode
Description This command is used to select the output mode for the Model 2430.
The DC parameter selects the DC Mode of operation, and PULSe
selects the Pulse Mode.
Control auto output-off
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
To Next Page
Loading...
Need help?
General
