Kemppi KEMPACT 253R User Manual

EN
4. Cut away any deformed ller wire section and dress the sharp wire tip.
5. Connect the welding gun and tighten the collar.
6. Press the welding gun trigger and allow the ller wire to feed through the gun cable to
the contact tip.
Check once again that the ller wire is still properly seated in the grooves of both top and
bottom feed rolls.
4.5 Welding gun
Connect the welding gun connector to the Euro adapter socket located below the wire feed
mechanism and hand tighten only. Do not over tighten the gun collar.
NOTE! Remember to remove the sharp cut tip of the ller wire before loading the wire to the
welding gun, so preventing damage to the liner inside the welding gun cable. This is particularly
important for soft ller wires such as aluminium. It will also improve feed quality and increase the
service life of your gun liner.
Kempact 251R, 253R, 323R, 181A, 251A, 253A, 323A
12

Kemppi KEMPACT 253R Specifications

General

Brand	Kemppi
Model	KEMPACT 253R
Category	Welding System
Language	English