EN
3.2 Cable connections
Connection to the mains
Kempact RA models are available in either 1-phase 230 V, 3-phase 400 V, or multi-voltage
units. Machines supplied with a mains power cable are not equipped with a plug, so you must
select and t a suitable mains plug before you use the machine for the rst time.
Check that the mains cable complies with the local electrical regulations and replace the cable
if necessary. See ’Technical data’.
NOTE! The mains cable or mains plug may be installed or replaced only by an electrical contractor
or installer authorised to perform such operations.
Welding gun
Kempact RA welding machines are supplied with Kemppi FE range welding guns as standard.
These guns are designed for industrial applications and if used and maintained correctly will
provide productive and reliable service.
NOTE! The gun is set at the factory for use with ferrous ller wires. Should you wish to use the gun
with an alterative ller wire size or type, please select the appropriate contact tip and wire liner.
7
© Kemppi Oy / 1135
To Next Page
Loading...
Need help?
General
