@
P_CKfNG UP BOBBIH THREAD
1. Raise presser foot lever. Hold needle
thread loosely in left hand and rotate
handwheel toward you one complete
turn,
\
\
2, Bring bobbin thread up by pulling
upper thread,
3, Pull both threads under and to the
back of the presser foot, leaving 3 to
4 inches of thread clear°
If you cannot pick up bottom thread by
following steps given above, then
check:
1, is needle threaded from front to
back?
2. Is thread tangled around needle?
3. Is there 3 to 4 inches of thread coming
from the shuttle?
4. Is thread from shuttle tangled?
15
To Next Page
Loading...
