Kentec Electronics Sigma ZXT - How to Perform Panel Functions; Viewing Events and Logs

How to... 3
Man-1452EN Rev.02
Sigma ZXT Operation Manual
10
Section 3
How to...
The following Section provides information on how to perform common Panel functions.
View Active Events
When multiple active events exist on the panel the view active events function allows the user the ability to scroll
through details of each active event.
In access level 1 press the ‘X’ key, in USER MENU (Access Level 2) select the VIEW ACTIVE EVENTS menu option
1. The VIEW ACTIVE EVENTS screen provides a synopsis of how many active events of each type exist on the panel.
2. Use the up/down cursor keys to select the event type to view and press enter key.
3. Details of each of the active events of the type selected can be scrolled through using the up/down cursor keys.
View Event Log
The panel stores up to 1000 events within its memory these events can be scrolled through on the screen, providing
diagnostic information:
1. Enter USER MENU (Access Level 2) using passcode or enable key switch.
2. Select EVENT LOG FUNCTIONS menu option.
3. Alarm counter screen will be displayed, with the text at the top DISPLAY ON SCREEN. Press enter to view
events on screen.
4. Use the up/down cursor keys to scroll through event log events on the LCD.
5. To filter event types use the left/right arrows.
Note: The EVENT LOG FUNCTIONS screen also shows an alarm counter, indicating how many alarms have been
activated on the control panel.
Put a Detection Zone Into Test Mode
Test Mode enables automatic detection devices connected to zones to be tested without the risk of activating an
extinguishant. During test any alarms activated will be indicated on the Control Panel but no operations will be ac-
tioned.
To place a zone in Test mode:
1. Enter USER MENU (Access Level 2) using passcode or Enable key switch.
2. Select TEST menu option.
3. Use up and down cursor keys to highlight zone to put into Test.
4. Use left/right cursor keys to change zone setting to read IN TEST.
5. Zonal test and general Test LEDs will be illuminated.
Once testing is complete zone can be returned to NORMAL mode using the same menu setting.