Kenwood CS-5200 Series - Bottom P L a T

® Fuse holder, line voltage selector
Use a 1 A fuse In 100/120 V areas. Use a 630 mA fuse in 220/230/240 V areas.
Changing the voltage rating should be done strictly according to the directions In
section 9. FUSE REPLACEMENT, LINE VOLTAGE SELECTION only after disconnecting the power
cord from the power source Inlet,
® Power cord receptacle
A commercialy-used power source input connector.
5-3 Bottom Plate
Figure 3 Bottom Plate
© AST1G control
Controls the trace or spot astigmatism. Astigmatism has been adjusted before shipment.
If necessary, adjust the waveform to the optimum condition with the ASTIG and FOCUS
controls.
NOTE
Do not use a metallic device for astigmatism adjustment to avoid accidents.
Use the insulated screwdriver included in the accessories.
21