Kenwood CS-5200 Series - Readout D I S P L a; D I S P L a y P O S I T I O N; D I S P L a

5-4 Readout Display [CS-5230, 5260, 5270]
1) Display positions
Figure 4 below shows the display positions of the scale factors and the values
measured with the cursor.
©Cursor mode
©Cursor measurement
(©Delay time)
©CH2 (CH3)
scale factor
Figure 4 Readout Display
2) Display
® Cursor mode
The fol1 lowing cursors are displayed according to the setting of the controls.
AVI, AV2, AV3, AT, 1/AT, RATIO, PHASE
® Cursor measurement
A value measured with two cursors is displayed.
• NOTE
If two cursors are too near beyond the measuring limits in the 1/AT mode, "?"
is displayed following "1/AT", indicating that the measured value has an error
out of standard.
(D Delay time
If the H. MODE is set to ALT or B, "DELAY" is displayed at the cursor mode
position and the delay time is displayed at the cursor measurement posit ion. If
TRIG' D is selected or the cursor measurement is located within 0.2 division from the
left side of the CRT, DELAY is followed by "?", indicating that the measured value
has an error.
Voltage or time cannot be measured with the cursors during delay time display.
©Cursor mode
©Cursor
measurement
©CHI scale factor
©ADD
©CH2 INV
(DB sweep scale factor
®A sweep scale factor
22