Kenwood CS-5200 Series - Fuse Replacement, Line Voltage Selection

9. FUSE REPLACEMENT, LINE VOLTAGE SELECTION
Before conducting the following operation, turn the power off and unplug the power cord
from the wall socket.
Fuse Replacement
If the fuse blows, the osci1loscope wi11 not operate. Locate the cause. If the
oscilloscope is not defective, remove the cap from the fuse holder on the rear panel
with a standard type screwdriver, then replace the fuse with a new fuse. (See Figure
24.)
100 or 120 V : 1 A (Time lag)
220, 230 or 240 V : 630 mA (Time lag)
| NOTE 1
If any of the following cases apply, please contact your dealer, or our
distributor.
• It is not clear why the fuse has blown, or the oscilloscope seems to be defective.
• The oscilloscope uses a time lag type fuse. If a time lag type fuse of the above-
shown rating is not available.
Changing Voltage Select ion
Remove the fuse holder and voltage selector from the rear panel with a standard type
screwdriver. Fit the 1ine voltage selector to match the supply voltage rat ing
(T mark). If 100 or 120 V is to be changed into 220, 230 or 240 V, the 1 A fuse should
be replaced with a 630 mA fuse. (See Figure 24. )
Fuse Holder
Figure 24 Changing Voltage Requi rements
50