Kenwood CS-5200 Series - Measuring Phase Difference

5) If phase difference Is negligible and the horizontal distance is short, press the x10
MAG switch in this condition.
With the x 10 MAG switch pressed, the phase difference is 4.5 degrees for every
division.
• Cursor measurement [CS-5230, 5260, 5270]
(1) Carry out step 1 of observation with the scale on the CRT.
(2) Adjust the SWEEP TIME/DIV nad H. VARI controls so that one period of the waveform is
5 div.
(3) Press the CURSOR MODE switch to select the time and frequency mode. Align the
AREF cursor and A cursor to the corresponding points of two waveforms. Read
the measurement.
Figure 20-2 Measuring Phase Difference (Cursor measurement)
47
1 cycle
Reference signal
Comparison
signal
Phase difference
Figure 20-1 Measuring Phase Difference
Measured value
REF cursor
cursor