SettingsSettings
4
Repeat steps 2 and 3 to register other
buttons.
5 Touch [Done] to finish the procedure.
• The unit can register all of the buttons’ functions at
the same time. To do this, press all buttons in turn
and after pressing all of them, touch [Done] on the
<Steering Remote Controller Setting> screen.
However, new functions cannot be learned after this
operation.
To change the previously assigned function:
① Touch the key to change on the <Steering Remote
Controller Setting> screen.
② Select a new function to assign from the function
list.
③ Touch [Done] to finish the procedure.
To initialise the setting: Touch [Initialise] for
<Steering Remote Controller>.
A confirmation message appears. Touch [Yes].
• To cancel the initialisation, touch [No].
<GNSS Version>
Updates the Global Navigation Satellite firmware.
<DAB Module Version>
Updates the Digital Audio Broadcast (DAB) module
application.
• Do not disconnect the USB device while updating.
• If the update has failed, turn the ignition switch off
then on, and retry the update.
<Open Source Licenses>
Shows the Open Source Licenses.
<System Information>
Update the system by connecting a USB device
containing an update file.
• To obtain the update file, visit
<https://www.kenwood.com/cs/ce/>.
Connect a USB device with the update file to the unit.
Update
System Information
GNSS Version
Application Version
Update
Update
System Version
Update
Vxxx
Vxxx
Vxxx
DAB Module Version
Vxxx
Update starts. It may take a while. If the update has
been completed successfully, “Update Completed.
Please switch ignition off” appears.
<Application Version>
Updates the system application.
<System Version>
Updates the system.
45
ENGLISH
00DMX7722DABSE.indb4500DMX7722DABSE.indb45 2022/10/1716:202022/10/1716:20
To Next Page
Loading...
Need help?
General
