Kenwood KMM-U21 - GETTING STARTED; Initial Setup Procedures

4
Data Size: B6L (182 mm x 128 mm)
Book Size: B6L (182 mm x 128 mm)
GETTING STARTED
Cancel the demonstration
When you turn on the power (or after you reset the unit), the display
shows: “CANCELDEMO”
“PRESS” “VOLUMEKNOB”
1 Press the volume knob.
[
YES ] is selected for the initial setup.
2 Press the volume knob again.
“DEMOOFF” appears.
Set the clock
1
Press the volume knob to enter [ FUNCTION ].
2 Turn the volume knob to select [ CLOCK ], then press the knob.
3 Turn the volume knob to select [ CLOCK ADJUST ], then press the
knob.
4 Turn the volume knob to make the settings, then press the knob.
Day
Hour Minute
5 Turn the volume knob to select [ CLOCK FORMAT ], then press the
knob.
6 Turn the volume knob to select [ 12H ] or [ 24H ], then press the knob.
7 Press and hold to exit.
To return to the previous setting item, press .
While in clock display screen...
Press and hold to enter clock adjustment mode directly.
Then, perform step
4 to set the clock.
1
Set the initial settings
1
Press repeatedly to enter STANDBY.
2 Press the volume knob to enter [ FUNCTION ].
For : Pressing AUD enters [ AUDIO CONTROL ] directly.
3 Turn the volume knob to make a selection (see the following table),
then press the knob.
4 Repeat step 3 until the desired item is selected or activated.
5 Press and hold to exit.
To return to the previous setting item, press .
Default:
XX
AUDIO CONTROL
SWITCH
PREOUT
REAR / SUB-W : Selects whether rear speakers or a subwoofer are connected
to the line out terminals on the rear (through an external amplifier).
SP SELECT OFF / 5/4 / 6 × 9/6 / OEM : Selects according to the speaker size (5inches
or 4inches, 6×9inches or 6inches) or OEM speakers for optimum
performance.
TUNER SETTING
PRESET TYPE
NORMAL :Memorizes one station for each preset button in each band
(
 5 ).; MIX :Memorizes one station for each preset button, regardless of
the selected band.
SYSTEM
KEY BEEP
ON :Activates the keypress tone.; OFF :Deactivates.
TDF ALARM ON :Activates the alarm if you forget to detach the faceplate when ACC is
set to OFF.;
OFF :Deactivates.
SOURCE SELECT
PANDORA SRC
(For )
ON
:Enables PANDORA in source selection.; OFF :Disables. (  9 )
BUILT-IN AUX ON :Enables AUX in source selection.; OFF :Disables. (  10 )
2
3
JS_KWD_KMM_U21_MN_EN_4.indd 4JS_KWD_KMM_U21_MN_EN_4.indd 4 2/9/2014 9:56:52 AM2/9/2014 9:56:52 AM