Kenwood NX-5200 Service Manual

1-46 (No.RA018<Rev.002>)
4.9 Transmitter Section
5.
RTC
Corre-
citon
1) Adj item:
[RTC]
Adjust:[****]
Press [ ] key
to store the ad-
justment val-
ue.
1) Adj item:
[RTC Correction]
Data: {****]
Press [Apply] button
to store the adjust-
ment value.
Fre-
quency
Counter
Panel
TEST
POINT
(CN709
or
CN710)
[Panel
tuning
mode]
[
 ], [  ]
[PC test
mode]
[
← ], [ → ]
[Panel tuning mode]
Press [ ] key to store
the adjustment value.
[PC test mode]
Press [Apply] button to
store the adjustment
value.
Remaks:
Change the adjust-
ment value so that
the frequency cur-
rently displayed on
“Crystal Oscillation
Frequency” on the
PC window and the
frequency currently
displayed on the
frequency counter
are in agreement.
Item Condition Measurement Adjustment Specifications
/Remarks
Panel tuning
mode
PC test mode Test-
equip-
ment
Unit Ter-
minal
Unit Parts Method
Item Condition Measurement Adjustment Specifica-
tions
/Remarks
Panel tuning
mode
PC test mode Test-
equip-
ment
Unit Ter-
minal
Unit Parts Method
1.
Ramp
up
Offset
1) Adj item:
[RAMPU]
Adjust:[****]
PTT : ON
Press [ ] key to
store the adjust-
ment value.
1) Adj item:
[Ramp Up Offset]
Press [Transmit]
button.
Press [Apply]
button to store the
adjustment value.
Power
meter
Ammeter
Panel ANT Panel [Panel
tuning
mode]
[],
[]
[PC
test
mode]
[←],
[→]
[PC test mode]
[Automatic Adjust-
ment]
1) Press [Tune Rump
Offset] button.
2) Press [Apply All] but-
ton to store the adjust-
ment value after the
automatic adjustment
has finished.
[Manual Adjustment]
1) Set the adjustment
value to “1”.
2) Increase the adjust-
ment value slowly while
monitoring the offset
monitor value.
3) Set the adjustment
value when the offset
monitor value exceed
“50”.

Kenwood NX-5200 Specifications

General

IP Rating	IP67
Zones	128
GPS	Yes
Bluetooth	Yes
Voltage Range	7.5V DC ±20%
Operating Temperature	-30°C to +60°C
Frequency Range	136-174 MHz
Battery Life	14 hours (Digital mode)
Digital Protocol	NXDN, DMR
Display	LCD