Kenwood TH-D74A/E - Memory Channels; Using the Memory Groups

6 Settings & Controls
53
6.9 Memory Channels
Using the Memory Groups 6.9.1
The TH-D74A/E offers 30 memory groups from "GRP-0 to GRP-29".
Each memory group can be assigned with a group name of not more than 16 characters.
When a new memory is registered, a default memory group number will be registered to the
memory channel as follows according to the channel number that users register the group
numbers again according to the intended use.
To do so, press the [ENT] [MENU] keys while in the Memory Channel mode to enter the
Memory Channel List Menu, followed by selecting [Edit] - [Group] to change the group of
the selected channel.
Memory Channel No. Memory Group Group Name
Example of
Registered Name
0 to 99
Group 0
GRP-0
AMA 144
100 to 199
Group 1
GRP-1
AMA 430
200 to 299
Group 2
GRP-2
D-STAR
300 to 399
Group 3
GRP-3
・
400 to 499 Group 4 GRP-4
・
500 to 599
Group 5
GRP-5
Aviation radio
600 to 699
Group 6
GRP-6
AM radio
700 to 799
Group 7
GRP-7
・
800 to 899 Group 8 GRP-8
・
900 to 999 Group 9 GRP-9
・
Pressing the [MR] key switches to the Memory Channel mode and activates the
"All Groups" state in which all the groups will be recalled at the same time. The default
setting is "All Groups". To change the memory groups to recall, press and hold
the “◄” or “►” key while in the Memory Channel mode.
The new memory group will be displayed for two (2) seconds when a change has been
made, after which only the Memory Channel registered in the memory group can be
recalled.
ALL Groups
(All memories can be recalled)
Group-0
(Only memories registered in the displayed
group can be recalled)