KERN CFS 300-3 - Page 125

38 CFS/CCS-BA-e-1624
 Put on the weighed material and check whether the weighed material is within
the given tolerance, alongside the tolerance mark

/ acoustic signal.
Display of tolerance mark

, if weighing goods are under the specified tolerance:
Display of tolerance mark

, if weighing goods within the specified tolerance:
Display of tolerance mark

, if weighing goods above the specified tolerance:
 For tolerance control, also only one limit value can be set.
 If both limit values are deleted, the tolerance control is deactivated.
 Delete limit values:
When inputting the upper and lower threshold press and confirm with
the TARE-key.