TEFC_A-BA-e-2110 27
Tolerance check start:
Ensure the average weight of a single piece is determined (see chapter 8.6.
Place the weighed material (< 20 d) and, based on the tolerance symbols / audible
signal, check if the weighed material belongs to the preset tolerance range.
Weighed material below the preset tolerance
Weighed material in the preset tolerance range
Weighed material above the preset tolerance
• To cancel the limit values, enter <00000>.
• Deactivate the test weighing mode. To do it, press TOL the number of times
required until < > is displayed.
To Next Page
Loading...
