112 PRS/PRJ/ARS/ARJ-BA-def-0622
7 Modes of operation and use
7.1 Switching on the balance
• Press “ON/OFF“ to switch the scale on.
The balance carries out a self-diagnosis in order to test the most important functions.
After completion of the start-up process (approximately ten seconds) “Zero” appears in
the display.
The balance is ready for operation and is in weighing mode.
7.2 Auto-Standby-Mode
The balance is equipped with an Auto-Standby mode, which can be activated or
deactivated in the configuration menu.
If Auto-Standby mode is activated, the balance automatically switches to Standby mode
shortly after the last weighing or key operation (current-saving function).
The delay before switching to Standby is defined in the configuration menu (see Chapter
8.7 “Weighing mode”).
Press any key or put on a weight in order to switch the balance from Standby mode back
to weighing mode again.
7.3 Significance of the two main menus
The balance has two main menus available: the configuration menu and the application
menu.
The basic program of the balance is defined in the configuration menu.
In this way, you can either work with the basic configuration as programmed
in the factory, or define and store a user configuration adapted to your specific needs.
In the application menu, you define a working program, which is adapted to the specific
weighing situation.
In addition, you can also define the parameters for the statistics program and the
checkweighing program in the application menu.
To Next Page
Loading...
Need help?
General
