PRS/PRJ/ARS/ARJ-BA-def-0622 119
• If the balance is blocked, it must first be disconnected from the power supply, then
reconnected and unblocked by entering the correct four-digit code.
• After seven consecutive incorrect entries the display will read “NO ACCESS, CALL
SERVICE”. In this case, only KERN Service can unblock the balance again.
NOTE
The anti-theft-encoding is deactivated from the factory.
The pre-programmed password set from the factory is: 8 9 3 7
This password is the same for all KERN balances. For reasons of security you should
therefore always enter your own code.
Keep your personal code in a safe place.
To activate the anti-theft encoding and to alter the code programmed in the factory to one
which you have chosen yourself, see Chapter 8.11 “Anti-theft encoding”.
To Next Page
Loading...
