KERN PRS

140 PRS/PRJ/ARS/ARJ-BA-def-0622
9.12 Setup for the statistics program
To activate the menu see Chapter 7.4 “Activating the two main menus” and Chapter 7.5
“How the menu control operates”.
• SETUP
STATISTICS
STATISTICS
MODE OFF
MODE STATISTICS
MODE RECORDER
MODE STAT./RECORDER
Statistics program only from
statistics
Only data storing stat. and
storing
NUMBER 100
Number of values which
should be collected
automatically (1 … 999).
MANUAL COLLECTION
COLLECTION ON TIMEBASE
COLLECTION ON LOAD
CHANGE
with function key
“STO”
on timebase
after every change in load
TIMEBASE 2.0
Timebase for “storing” in
seconds
• Functions of the statistics program and storing functions:
• MODE
- In this function field, you can define whether only the statistics program, only the
storing program or whether both programs are to be used at the same time.
• COLLECTION
- With “MANUAL” the function key “STO” must be pressed
for every value which is to be stored.
- With “CHANGE IN LOAD”, the balance automatically stores the
measured value after every change in load.
- With “TIMEBASE” the balance stores the measured value after each defined time
period (factory setting: 2.0 seconds).
• TIMEBASE
- Definition of the time period for the collection of data according to “COLLECTION
TIMEBASE” (e.g. every 2 seconds).
• NUMBER
- Definition of the number of values after which the store process should be
automatically completed.
NOTE
When storing the first value, a range of ±50 % is defined.
Subsequent values must be within this range, otherwise an error message will appear.