KERN PRS

PRS/PRJ/ARS/ARJ-BA-def-0622 139
• Display for “DENSITY” application on start-up
+ 0.9988205 g/cm
OK CAL T-H20 20.0C
U U U U
“Õ” “Ö” “×” “Ø”
• Function key legends during the weighing:
“AIR”, etc Request for measurement of the relevant value
«<–>»: “switch over” from index to density
“SET”: initiate the relevant step
“STO”: store the relevant value (statistics)
• Function key legends during the weighing:
Step
+ 123.456
9
1
AIR SET
2
FLOOR SET
3
POROUS SET
4
LIQUID SET
5
DENSITY <—> STO
6
INDEX <—> STO
U U U U
«Õ» «Ö» «×» «Ø»
During operating steps (up to six may be
necessary), the info-line shows the
indications seen in this table.
If during step 5 or 6, the tare key “T” is pressed, then a reset is triggered.
The program guides the user through the individual operating steps.
For further information see Chapter 13.2.