◆Controller Over-current Cut Settings
Current Limit represents controller over-current cut settings. The current value can be
changed from 7.0A to 25.0A. The default value is 15A.
To change basic settings, press the “+” or the “-” button to increase or decrease the value of
the current.
To store a changed setting, press the “i” button to confirm.
Current limit setting
◆
Power Assistant Sensor Magnets
Assistant Num represents the number of magnets in the PAS disk.
To change magnet numbers, press “+” or “-” button to choose the desired number.
To store a changed setting, press the “i” button to confirm
Assistant Num setting interface
To Next Page
