Keyscan Inc. A Member of the Kaba Group – CA8WL-AL Rev. B Installation Guide (07.15)
S1.5 - Reader LED Mode
This DIP switch is not applicable.
S1.6 - Unassigned
Reserved for future use.
S1.7 - Temporary Card Countdown
The Client software has a card usage countdown function when credentials are issued on a temporary basis. To
employ this function in the Client software, the temporary card countdown DIP switch must be enabled on the
CA8WL-AL control board.
S1.8 – N/A
This DIP switch is not applicable.
S1.9 - Clear Memory Enable
The S1.9 DIP switch must be on to enable the J1 Clear Memory jumper for restoring the factory defaults.
S1.10 & S1.11 - Communication Terminal Activation
DIP switches S1.10 and S1.11 activate the RS-232 terminal for direct serial communication or network
communication with the internal, on-board Ethernet module for run mode or program mode.
S1.12 - Flash Program Memory Upgrade
Currently, this function is unavailable.
To Next Page
Loading...