Keyscan CIM-LINK - Page 25

CIM-LINK Setup Guide
25
Worksheet
The attached worksheet can be used to record settings of ACU, CIM and CIM-LINK
modules. We suggest making sufficient copies of the worksheet so you have a record of
settings at each panel location. Circle appropriate settings or jumper pins (ON) and list
network addresses.
Control Board
Model
Serial #
Baud Rate
CIM 0
Yes No
Serial Network
If network
Jumper J4
ON OFF
IP Address
MAC
Subnet
Gateway
CIM #
Global Master
J3 ON
J3 OFF
CIM-LINK
J3
ON OFF
IP Address
If J3 ON
Global Master
MAC
Group Master
Subnet
J4 Single ACU
ON
Gateway
J4 Group ACUs
OFF
Port 3001
CAN Bus 2
Termination
J7 & J8
ON OFF
Virtually connected to CIM-LINK Module – IP Address