Need help?Do you have a question about the Keyscan CA150 and is the answer not in the manual?
General| Model | CA150 |
|---|---|
| Type | Single Door Controller |
| Input Voltage | 12-24V DC |
| Max Doors Supported | 1 |
| Door Capacity | 1 |
| User Capacity | 10, 000 |
| Compatibility | Keyscan Aurora Software |
| Reader Capacity | 2 |
| Communication Protocol | RS-485 |
| Inputs | 4 |
| Operating Temperature | -20°C to 50°C |
Safety guidelines for electrical work during installation.
Procedure to program the unit's Ethernet module for network communication.
Steps to set up the unit for reverse network communication.
Procedures for proper grounding of the unit and cables.
Settings for communication mode, bit rate, and other system configurations.
Settings to configure the unit for different reader formats.
Settings for input supervision levels (door, exit, alarm).
Selects the Keyscan software application for the control board.
Procedure to reset the control board to factory defaults.
Interpreting communication status LEDs for troubleshooting.
Understanding the system status LED for operational feedback.
Details on creating and using encryption keys for secure communication.
Configuring DIP switches for reverse network communication.
Assigning an IP address to the access control board for network setup.
To Next Page
