Keyscan CA150 User Manual

Keyscan Inc. A Member of the Kaba Group – CA150 Rev. B Installation Guide (07.15)
67
Keyscan / HID Readers
This section reviews typical connections for Keyscan readers and HID readers. Wiring diagrams are on the
following pages. Refer to the appropriate diagram for specific reader connections. Be sure to use a cable that
complies with the reader’s wiring specifications.
Power Specifications
The following table outlines Keyscan and HID reader power requirements.
Table 13 – Keyscan & HID Reader Power Specifications
Reader
Power
Notes
K-PROX2 & K-PROX SG (125 kHz)
12 VDC, 80 mA
K-VAN
12 VDC, 90 mA
K-KPR
12 VDC, 115 mA
K-SMART (13.56 MHz)
12 VDC, 210 mA
K-SMART GOV (Legacy)
12 VDC, 210 mA
HID-5365
12 VDC, 110 mA
HID-5395
12 VDC, 115 mA
HID-6005
12 VDC, 75 mA
HID-5455
12 VDC, 125 mA
HID-5355KP
12 VDC, 120 mA
HID 5375
24 VDC, 1.5 A
Requires 18 AWG cable. Connect to separate 24 VDC 2
Amp linear power supply. (Not supplied with ACU)
HID iClass Legacy
HID Base Part #
KR10L
12 VDC, 60 mA
900N
KR40L
12 VDC, 65 mA
920N
KRK40L
12 VDC, 85 mA
921N
HID multiClass Legacy
KRP10L
12 VDC, 75 mA
900P
KRP15L
12 VDC, 75 mA
910P

Keyscan CA150 Specifications

General

Brand	Keyscan
Model	CA150
Category	Control Unit
Language	English