Keyscan Inc. A Member of the Kaba Group – CA150 Rev. B Installation Guide (07.15)
Facility code range 1 – 255
Card number range 1 – 65535
Extended Card Number – hexadecimal 0-9, A-F or decimal 0 – 9
Hexadecimal range 1 – FFFFFFFFFFFF
Decimal range 1 – 281474976710655
*The facility code may also be referred to as the site code or the batch code.
Extended Card Number – Card Enrollment
Please be advised that reader formats Ref # B, D, E, F, G, H, I, & J, listed in the following table, are referred to
as extended card number support reader formats. These reader formats require a different method of card
enrollment in which the Client software must make hexadecimal/decimal calculations. As opposed to merely
entering the facility code and card number in the cardholder record, use the following procedure to enroll a
card when the control board is configured for extended card number support. You must also enable the site for
extended card number support in the Client software’s Site Information screen.
If a high volume of cards is involved, you may wish to connect a reader close to a PC with the Keyscan Client
and use it as a designated card enrollment reader. You can access the Client help by pressing F1.
From the Client software, select the Display On-line Transactions quick button on the main screen.
Ensure that the On-line Transactions screen is open. Present the card at a reader.
At the PC with the Keyscan Client, the card is listed in the transaction table. The card will show ‘access
denied’ under Transaction Type in the On-line Transaction screen. This is normal as the card has not yet
been enrolled. Hold down the Ctrl key on the keyboard and double click on the card number under the
card heading.
The Cardholder Information screen opens and you will see the card number (hex) field is populated from
the reader scan. The card number is displayed below.
Complete the remaining cardholder fields and then save the record.
Supported Keypad Wiegand Outputs
Keyscan supports the following keypad PIN data Wiegand outputs:
HID Wiegand with 4-bit word burst
Indala unbuffered mode Wiegand with 8-bit word burst
WSSKP-1 facility code 0 (zero) with 36-bit Keyscan Wiegand output
If using 3
rd
party biometric devices connected to Keyscan CA or EC control board reader ports, do not use
reserved facility code 0 (zero).
To Next Page
Loading...
Need help?
General
