Keyscan CA150 User Manual

Keyscan Inc. A Member of the Kaba Group – CA150 Rev. B Installation Guide (07.15)
64
Diagnostics
The CA150 has communication and system status LEDs on the left side of the control unit for diagnostics.
Communication LEDs
The CA150 has on-board LEDs for communication diagnostics outlined in the table below. If calling Keyscan for
technical support, indicating the state of the LED assists our technicians in isolating potential difficulties.
Table 11 – Communication LEDs
CA150 Control Board
LED
State of LED
Notes
TD 1 - Green
Flashing – normal
Main processor sending data to on-board supervised inputs processor or
RS-485 port
Not Illuminated – abnormal
condition
Follow restore factory defaults J1 procedure in attempt to resolve.
Illuminated – abnormal
condition
Follow restore factory defaults J1 procedure in attempt to resolve.
RD 1 - Red
Flashing – normal
Main processor receiving data from on-board supervised inputs processor
or RS-485 port
Not Illuminated – abnormal
condition
Follow restore factory defaults J1 procedure in attempt to resolve
Illuminated – abnormal
condition
Follow restore factory defaults J1 procedure in attempt to resolve
Possible wiring fault
TD 2 – Green
Flashing – normal
Control board sending data via communication path determined by S1.10
& S1.11 to Client/Communication Mgr
Not Illuminated
If Client/Comms not polling the control board
If S1.10 & S1.11 are configured for on-board NETCOMP programming
Illuminated – abnormal
condition
Follow restore factory defaults J1 procedure in attempt to resolve
RD 2 – Red
Flashing – normal
Control board receiving data via communication path determined by
S1.10 & S1.11 from Client/Communication Mgr
Not Illuminated
If Client/Comms not polling the control board
If S1.10 & S1.11 are configured for on-board NETCOMP programming
Illuminated – abnormal
condition
Possible wiring fault

Keyscan CA150 Specifications

General

Brand	Keyscan
Model	CA150
Category	Control Unit
Language	English