Keysight Technologies InfiniiVision 3000 X Series User Manual

345
Keysight InfiniiVision 3000 X-Series Oscilloscopes
User's Guide
23 CAN/LIN Triggering and
Serial Decode
Setup for CAN Signals / 345
CAN Triggering / 347
CAN Serial Decode / 349
Setup for LIN Signals / 353
LIN Triggering / 355
LIN Serial Decode / 356
The CAN/LIN triggering and serial decode option is license-enabled.
Setup for CAN Signals
Setup consists of connecting the oscilloscope to a CAN signal, using the Signals
Menu to specify the signal source, threshold voltage level, baud rate, and sample
point.
To set up the oscilloscope to capture CAN signals, use the Signals softkey which
appears in the Serial Decode Menu:
1 Press [Label] to turn on labels.
2 Press [Serial].
3 Press the Serial softkey, turn the Entry knob to select the desired slot (Serial 1 or
Serial 2), and press the softkey again to enable decode.
4 Press the Mode softkey; then, select CAN trigger type.
5 Press the Signals softkey to open the CAN Signals Menu.

Keysight Technologies InfiniiVision 3000 X Series Specifications

General

Brand	Keysight Technologies
Model	InfiniiVision 3000 X Series
Category	Test Equipment
Language	English